How to Resurface Your Deck

How to Resurface Your Deck

The surface of a wood deck will most likely spoil ahead of the foundation because of all the elements involved. When rain falls on your deck it causes swelling and warping. When the sun hits the deck, it causes drying and cracking. No matter how affected the wood is by the elements, it can be restored if it is not infected by fungus or rotten. The life of your deck will be well extended by a resurfacing treatment. You will need to prepare the deck for resurfacing, by cleaning the wood before starting. There are different ways and methods to go about this. Here is a good guide to start with.

Wash the deck boards

For deck resurfacing in Maryland, you should start by washing the boards. Do this by hand, with a stiff brush or broom. This is not as harsh on the deck but will reach deep cracks and corners properly.

You can use a power wash machine with moderate energy so it does not result in discoloration, gouging or splintering of the wood. Use a commercial cleaner.

You can use a chemical stripper to treat stubborn stains and areas more exposed to wear. This will make the wood cleaner than ordinary washing. Remember to wash any nearby plants before and after this to protect them from chemical damage.

Allow it to dry

As you let the boards dry from washing, deal with loose screws or nails that are sticking out. One or two days is a good time to let the deck dry.

Fix cracks

While carrying out deck resurfacing in Maryland, you will need to fix the cracks with a wood filler. Select a clear option or one that is the same color as the wood. Scrape off the excess to make sanding easier.

Remove overly damaged boards

Check the boards to see the state. If there is any that is too damaged to be fixed, then pry it out and switch to the underside. The foundation might be in better condition. If that is also too damaged, then you will have to replace the damaged board completely.

Sand the deck

You should sand the wood by hand or with an orbital flooring sander to remove splinters and smoothen the edges for the protective coat. Blow away or vacuum the dust produced from sanding.

Complete with a protective coating

You can use a paint roller for this. Attach a long handle so you don’t have to stoop low or kneel for this. Take the coating a few deck boards at a time so you don’t over coat some boards. An ordinary paint brush can be used but it may be difficult for a large area and might not be even.

Another option is a sprayer with which you can cover large areas faster and more uniformly. Simple pump or powered spray painters will work well. If using a gel stain, a pad is better for avoiding running and dripping.

Cracks and splinters will be reduced when you carry out deck resurfacing in Maryland every year or every two years. This is ideal for bare feet and better look.

Leave a Reply